THOMSON Grass Valley KAM-XM Series, Инструкция по эксплуатации

Страница: 38 / 80

38 KAM-XM-SERIES Instruction Manual
Configuration and Adjustments
Links and Web Pages
The Kameleon 2000 GUI provides the following links (see graphic at left) to
configuration web pages for all of the modules covered in this manual
unless otherwise specified:
• Status – reports input signal status, warnings, and module information
including part number, serial number and software versions (
page 39 )
• License – reports the module type ( page 41 )
• Setup – provides controls for selecting the video reference for the
module, the genlock offset, closed captioning lines and blanking con-
trols (
page 42 )
• Format – provides controls for setting input and output format
(
page 44 )
• Aspect – provides aspect ratio conversion options ( page 46 )
• ProcAmp – provides processing amplifier controls ( page 48 )
• Detail Enhance – provides horizontal and vertical detail enhancement
controls (
page 49 )
• The following web pages are available only with the KAM-XM-UNC
module:
• Spike – provides adaptive median filter for random noise removal
(
page 50 )
• Brickwall – provides a low pass filter with a sharp cutoff for
impulse and gaussian noise conditions (
page 51 )
• Temporal Recursive – provides a motion adaptive filter for
removing random and gaussian noise (
page 52 )
• Mosquito – is not available in this application ( page 55 )
• Advanced Aperture – is not available in this application ( page 55 )
• Color Legalizer – provides luma and chroma high and low limit con-
trols for setting legal color limits (
page 56 )
• Grain Insertion – is not available in this application ( page 57 )
• GPI – enable and assign E-MEM registers to GPI Inputs 1-3 for external
recall (
page 58 )
• E-MEM – provides ten Preset registers for store and recall of module
configuration (
page 59 )
• Slot Config – provides Slot ID and Memory functions, Frame Health
reporting and SNMP reporting enable/disable controls (
page 65 )
• Software Update – gives software update information ( page 68 )
A summary of all configuration value ranges, defaults, and control types is
given in
Table 5 on page 30 .