THOMSON 500013, Руководство пользователя

Страница: 19 / 28

To set the upper end stop (opening), follow the
same steps:
• Open the shutter using the 'ON' button on
your remote control.
• Stop the movement by pressing briefly and
releasing the shutter button.
• Then hold the button as long as required until
the shutter is completely open.
• Then record the shutter's current position by
pressing the ' OFF ' button on your remote
control.
3 - PROGRAMMING WITH OTHER
ACCESSORIES
Any element can be paired with other devices from
the range: wall remote control, remote control light
bulb socket, universal drive relay, Thombox, etc.
• To pair the remote control with another device
to be controlled, press and hold the 'on' and
'off' buttons for the channel you want to use
at the same time for 3 seconds. The LED on
the remote control blinks red.
• Then place the device to be controlled into
pairing mode. Refer to the device's user guide
to find out how to do this.
Note: You can pair up to five devices per channel.
To pair the management module and the motor
with another control device, refer to the user guide
of the device you want to pair with your product.
During pairing, you will be asked to put the
management module into pairing mode:
• When asked to put the management module
into pairing mode, press and hold the pairing
button on the front of the receiver module for
at least 3 seconds.
4 - INVERTING RAISING AND LOWERING
If the control devices open the blind or shutter when
you ask them to close and vice versa, pressing
briefly on the management module's pairing button
will invert raising and lowering.
19
EN
E - CONFiGurATiON
20Nm drive kit
for rolliNg shutters aNd bliNds