Important safety instructions
EN
2
Warnings and precautions
Ensure that your domestic mains supply voltage
matches the voltage indicated on the identification
label located at the back of the set.
The TV set’s components are sensitive to heat.The
maximum ambient temperature should not exceed 35°
Celsius.
Do not cover the vents at the back of the TV set.
Leave sufficient space around it to allow adequate
ventilation.
Install the TV set away from any source of dust or heat
(radiator, etc.). Do not expose it to direct sunlight.
Moisture in rooms where the set is installed should
not exceed 85% humidity. If you have to use the TV set
outdoors, do not expose it to rain or splashing water.
Moving the set from a cold place to a warm one can
cause condensation on the screen (and on some inside
components). Let the condensation evaporate before
switching the TV set on again.
During thunderstorms, we recommend that you
disconnect the set from the mains and aerial so that it
is not affected by electrical or electromagnetic surges
that could damage it. For this reason, keep the mains
and aerial sockets accessible so they can be
disconnected if needed.
Unplug the set immediately if you notice it giving off a
smell of burning or smoke.You must never, under any
circumstances, open the set yourself, as you risk an
electric shock in doing so.
If you intend to be away for a long period, switch the
set off at the on/off switch located on the rear panel
(see the figure below).
Even when off, some components remain in contact
with the mains electricity supply.To completely isolate
the set you must remove the plug from the mains
supply socket.
This product is fitted with a 3-pin grounded plug, which
will only fit into a grounded power outlet.This is a
safety feature. Do not alter the plug, as this would
defeat the safety feature.
Avoid any intrusion of liquid or small metallic objects
inside the set. If such an incident were to occur,
immediately disconnect the TV set from the mains
supply and refer servicing to qualified service
personnel.
Use the screen saver when using a computer.
Switch the TV set to standby mode when you do not
use it.
The top of the TV set is usually very hot due to the
high temperature of exhaust air released through the
ventilation openings. Do not place your hands or face
close to these openings to avoid burns or personal
injuries. Do not place any object close to the
ventilation openings to avoid any damage to the object
or to the TV set itself.
Make sure that all cables are disconnected before
moving the TV set, to avoid damaging the cables and
thus cause fire or electric shock danger.
100 ~ 240 V
50/60 Hz
main power
switch
42pb120S4-en 2/07/04 11:32 Page 2
