2 Plasma Monitor
Safety Warnings
Important Recommendations
Important Recommendations
Warning :your monitor is heavy and its weight centred towards the top.
Handle it with care. Unpacking and installation requires at least two people.
For the installation to be correct, we strongly advise you to contact a
registered and qualified THOMSON dealer.
When you choose a specific support, read through the supplied notice for
details on fixing and attaching your equipment.
Installation
This monitor requires a mains voltage of 220 - 240~ 50Hz. Any lengthy use
with a higher voltage may damage your monitor or even provoke a fire. In
case of thunderstorms, it is recommended to disconnect the mains plug. If
you notice any smell or smoke coming out of your monitor, disconnect the mains plug immediately. To do so, leave the
mains plug accessible to allow an easy and quick disconnection. During long absences, we recommend you to turn off your
monitor through the Main power button and even to disconnect it from the mains.
Safety
Ensure that the vents located at the rear are not covered and install your monitor far from any source of heat or dust. Do
not expose it to direct sunlight.
If you need to embed your monitor, leave sufficient
space around it for air circulation. Do not install it
directly near heating. The maximum ambient
operating temperature is 35° Celsius.
Your monitor has been designed to be used in dry
premises. If, exceptionally, you have to use it outside
(balcony, veranda etc.), make sure that it is
protected against humidity (dew, rain splashing). The
maximum operational humidity ratio is 85%.
Before using your monitor, if cold, in a warm room,
wait until any possible condensation found on the
screen has evaporated by itself.
Avoid any intrusion of liquid or small metallic objects
inside the monitor. If such an incident were to occur,
disconnect immediately your monitor from the mains
and call THOMSON after-sales service for help.
Ventilation - Heat - Humidity
Clean the screen with liquid products meant for glass. Never use abrasive products.
Clean front and cabinet using a soft cloth impregnated with a neutral detergent. Use of an alcohol-based solvent or
product may damage your monitor.
Regularly dust the air vents located at the rear of your device.
This monitor must be installed and used in compliance with this notice. It should not be used for other purposes.\,
including industrial purposes.
Maintenance
10cm
10cm
10cm
10cm
3cm