Thomashilfen Harmony Defender Reha CAN Version, Инструкция по сборке и эксплуатации

Страница: 16 / 36

16
Harmony Defender Reha – CAN Version – Booster seat – Accessories
Swivel base with footrest adapter (accessory) item code: 820/2
Please note our separate instructions for mounting! Download: www.thomashilfen.us
Footrest adapter (accessory) item code: 821/2
First pull off the 2 rubbers underneath the seat shell (Fig. 9a).
To be able to connect the Defender Reha with the footrest adapter, you must first
mount the adapter plate to the seat. Remove the four screws (phillips) that are
screwed into the seating shell of the Defender Reha from below (Fig. 9b).
Hold the adapter plate against the underside of the seat so that the countersunk bores
in the plate are on the bottom and the wider end of the adapter plate is up against
the rear end of the seat. Screw the plate onto the seat with the supplied longer screws
(Fig. 9c).
Now position the seat at a 90° angle flush to the front of the footrest adapter (handle
points forwards) and lower the seat onto the footrest adapter so that it is held in place
by the hook and loop strips. If you want to remove the seat from the footrest adapter
always do so by raising at the rear and tilting forwards. (Fig. 9d)
TRANSPORT: If transporting the seat with footrest adapter grasp the footrest adapter
with one hand by the front handle and hold the rear of the seat firmly in the other
hand. The seat and footrest adapter can also be transported eparately if too heavy.
FOOTREST: The footrest is mounted on the underside of the footrest adapter (loca-
tion tubes) (Fig. 12b).
UAS connector (LATCH) (for footrest adapter) (accessory) item code: 818
If your vehicle is equipped with UAS (Universal Anchorage System), the
vehicle UAS anchorage points may be visible at the seat crease. If not visible,
they may be marked with this symbol.
Check your vehicle owner’s manual for your vehicle’s exact UAS (LATCH) loca-
tions, anchor identifications and usage requirements for use with a child restraint.
NOTE: The UAS connector (LATCH) cannot be used if the vehicle does not have
UAS anchors (at least on the rear passenger side). Check before buying!
If UAS is not available in your car choose item 819 Stabilizing bow to install footrest
adapter.
First release the rear locking screw on the tube support beneath the footrest adapter
(the plate is rounded at this point). (Fig. 10a)