Thomashilfen Harmony Defender Reha CAN Version, Инструкция по сборке и эксплуатации, Страница: 17 / 36

17
Harmony Defender Reha – CAN Version – Booster seat – Accessories
Then lay the UAS connector (LATCH) onto the vehicle‘s seat. The bore holes at the
ends of the guide tubes must point downwards to the vehicle‘s seat. Guide the UAS
connectors (with yellow release buttons) (LATCH) into the vehicle‘s UAS anchors.
Check that the UAS connectors have locked into place safely by pulling. Now fit the
UAS connectior (LATCH) into the footrest apdapter‘s rear support (the plate is round-
ed at this point) with the released locking screw. (Fig. 10b)
Adjust the extension length of the UAS connector (LATCH) to your vehicle. The
child‘s car seat has to have contact with the backrest of the vehicle‘s seat when
mounted on the footrest adapter. Once the requested position is adjusted, carefully
raise the front of the footrest adapter until you can reach the rear locking screw and
tighten this correctly. (Fig. 10c)
WARNING: The UAS connector (LATCH) for the footrest adapter serves to position
the car seat and does not replace the safety belt. The child/ the seat always has to be
secured with the 3-point belt of the vehicle according to the user manual. Even when
seat is not occupied.
Stabilising bow (for footrest adapter) (accessory) item code: 819
First release the rear locking screw on the tube support beneath the footrest adapter.
Slide the stabilising bow on the rounded rear side into the tube support located there.
(Fig 11a)
Now place the footrest adapter onto the seat so that the stabilising bow can be slid in
as far as possible between the vehicle‘s backrest and seat. (Fig. 11b)
Adjust the extension length of the stabilising bow to your vehicle. The child‘s car seat
has to have contact with the backrest of the vehicle‘s seat, when mounted on the
footrest adapter.
Turn the footrest adapter around carefully and tighten the locking screw correctly.
The screw should hereby fit exactly into one of the safety bore holes of the stabilising
bow‘s guide tube.
NOTE: The stabilising bow can be used from both sides (Fig. 11c), try out both sides
in your vehicle to find o ut which offers the most stability for the footrest adapter.