Thomas SAR 460 SA G DIGIT, Руководство по эксплуатации и обслуживанию

Страница: 9 / 42

9
SAR 460 SA G
DESCRIPTION OF THE
OPERATING CYCLE
Before operating, all the main organs of the machine must
be set in optimum conditions (see the chapter on “
Regulat-
ing the machine
”).
6
- Ensure that the machine is not in emergency stop condition; if
it is, release the red mushroom button ( 1 ).
- Make sure that the flywheel metal Cover is closed as well as
the relevant Microswitch.
- Rotate the main switch ( 3 ) towards the right to position
1
.
- Press start button (
2
).
- Close the regulator ( 4 ) completely (turn it clockwise).
- Press the key activating the hydraulic pump (see legenda at
page 10) as well as the keys moving the sawframe and the
vice to verify if these work properly; if they doesn’t attempt to
swap one of the electric power supply wires (only during
installation).
- ATTENTION: having started the hydraulic unit motor, make
sure that the blade is under tension (eventually the blade
tension lever is released), so that the relevant microswitch
won't break the electrical circuit. Please refer to
para. 7.1 Blade
tension assembly
for more details.
- Press the key lifting the sawframe.
- Check the index showing the cutting angle; refer to
para. 7.4
Cutting angle adjustment
if you want to perform mitre cutting.
6.1 - Starting up and cutting cycle
1
1
3 4
2
- Display shows the following information soon after you switch
on the machine:
-
START
= start of the cutting cycle.
- PZ. I = programmed cutting cycles. The machines stops
automatically once the programmed number has been
completed; reset the piece-counter to start the machine again.
-
PZ. T
= programmed cutting cycles completed.
- VEL . LAMA or BLADE SPEED = current blade speed
expressed in meters per minute.
- F1 : corrisponding to the sign 'PZ' goes to the programming of
the piece-counter.
- F2 : corrisponding to the sign 'STATO' goes to the visualization
checking up the machine functions.
- F4 : corrisponding to the sign 'VEL' goes to the adjustment of
the blade speed.
START = BUTTON
PC. I = PC. T =
Blade speed Mt /m= ___
PC STATO VEL