THOMAS DÖRR TD 8000 FILL & GO, Руководство по эксплуатации

Страница: 40 / 48

Seite 40 von 48
2.
3.
There is too much
granulate in the
machine.
It is possible that
spoons transport
some granulate out
of the machine.
1c.
2.
3. dry to prevent too much water
getting into the machine.
The inserted cutlery was too wet. Let
the water drip off the cutlery to
prevent it from dripping into the
machine.
The machine may have been turned
off directly after a polishing
procedure. After use, allow the
machine to run for 30 minutes so the
granulate can dry.
›
Replace the granulate and
consider the heating process and the
drying procedure.
The axial fan may not be working
properly. Contact an authorized
service technician. The form of the
spoon makes it impossible to
eliminate that granulate falls out of
the machine.
Granulate
does not heat
up 1.
2. Heating element
malfunction.
Thermo element
malfunction. 1.
2. Contact an authorized service
technician
Contact an authorized service
technician
UVC lamp
does not
switch on 1.
UVC-lamp
malfunction.
1.
Replace the UVC lamp as described
in chapter 5.3. UVC lamps can be
ordered from us.
Granulate
dust particles
on cutlery 1.
2. New granulate.
Dishwash
detergent or rinsing
agent in the
dishwasher. 1.
2. Fresh granulate can cause more
dust deposits at first. When the
granulate has been heated up as
required, dump 4-5 shot glasses of
water into the feed chute of the
machine.
The cutlery is smeary, causing
granulate dust to stick on it. Wash
the cutlery by hand, rinse
thouroughly, then insert it into the
cutlery polisher again. If the
polishing results are good then there
was too much dishwashing
detergent in the dishwasher.
en