thomann The t.mix 16.4, Руководство пользователя

Страница: 13 / 28

16 [Aux1 Level] , [Aux2 Level]
Selects the bus Aux1 or Aux2 for setting the volume ( [EQ Gain / Level / Gain] control), balance ( [EQ Freq / Pan / THR]
control), compressor and equalizer, and for muting ( [Mute] button).
17 [Aux1 Send] , [Aux2 Send]
Opens the menu for selecting and setting the level of the input channels for the output [AUX Send 1] or
[AUX Send 2] . Use the [Parameter] control to select the input channel and set the level using the [EQ Q / Send / Ratio]
control.
18
[FX Send]
Opens the menu for selecting and setting the level of the input channels for the bus FX. Use the [Parameter] con-
trol to select the input channel and set the level using the [EQ Q / Send / Ratio] control.
19 [Hi / EQ1] , [Mid / EQ2] , [Lo-Mid / EQ3] , [Low / EQ4]
Opens the menu for selecting the characteristic values of the four parametric equalizers for the input channel or
bus that has just been selected
20 [Pan]
Selects in sequence the buses Aux1, Aux2 and FX for setting the volume ( [EQ Gain / Level / Gain] control), balance
( [EQ Freq / Pan / THR] control), compressor and equalizer, and for muting ( [Mute] button).
21 [COMP]
Opens the menu for selecting the characteristic values of the compressor for the input channel or bus that has just
been selected.
22 [GATE]
Opens the menu for selecting the characteristic values of the noise gate for the input or bus FX that has just been
selected.
23 [+48V]
Opens the menu for selecting turning the phantom power on and off for the input channel that has just been
selected. If the phantom power has been switched on, the button lights up red.
The phantom power leads to damage to the device if unbalanced cables are connected. Only switch on phantom
power while exclusively balanced cables are connected.
24 [Menu]
Opens the main menu
25 Level indicator for the [Main Out] output channel or the solo channel that has just been selected. The [Solo Meter]
button can be used for switching.
26 [Solo]
Assigns the input channel that has just been selected as a solo channel to the control room output.
27 [PFL]
Switches the the control room output between the operating modes Pre Fader Listen (PFL) and After Fader Listen
(AFL). Then the signal can be hear either like it sounds at the input or like it sounds under the influence of the tone
and volume controls.
28 [C Room]
Volume control for the control room output
Connections and controls
16.4
13