10
Secure the connection between the module and the factory OBD II connector that is
under the dashboard or on the side panel with a strap so that it does not impede the
ability of the airbag to deploy in the event of an accident.
11
Make sure that all vehicle trimmings removed during the previous steps of the
installation have been repositioned.
The steps below are only necessary if the optional rear camera is installed
1.
Using the above techniques, insert and route the cable through the casing from the
front camera to the mounting position of the rear camera. The cable will have a label
that indicates which side should go towards the front of the vehicle. See the slots A to D
for more information.
2.
Clean and dry the installation place with a cloth before placing the camera. Place the
camera in the rear window using the adhesive provided with the camera. Remember
not to place the camera in a place where it may interfere with the rearview mirror. It
may be necessary to connect to the dashboard using the Thinkware smart phone
application to verify that the orientation of the image is correct and that the entire rear
part of the vehicle enters the image. See figures E and F for more information.
3.
Make sure that all vehicle trimmings removed during the previous steps of the
installation have been repositioned.
