Thiel SI 1, Руководство пользователя

Страница: 11 / 16

Maintenance
Remote Control Battery Replacement
The green light on the front of the Remote Control should light when any of the buttons are pushed. If it does not the
batteries need to be replaced. Access the batteries by removing the four screws on the front of the unit using the hex driver
provided, and lifting off the front cover (see illustration below). Replace the three AAA size batteries, taking care to insert
the new batteries in the proper direction as indicated on the battery holder. The center battery should be positioned with its
small, positive terminal toward the bottom end of the unit, and the other two batteries in the opposite direction. When
replacing the panel some jiggling of the buttons may be required to align them with the holes in the panel.
Remote Control Interference
It is possible that the Integrator’s remote control will also affect other equipment or that the remote control of other
equipment will affect the SmartSub Integrator. In case this happens, the Integrator and its remote are able to operate on any
of 16 channels so that a channel can be selected that does not interfere with other equipment. A different channel is selected
by changing the settings of 4 miniature switches inside both the Integrator and its remote. Removing the top cover of each
piece using the hex driver provided allows access to the switches (see illustrations below). They can be switched to any of the
16 possible combinations but the settings in the remote must be the same as those in the Integrator. Experiment until a
channel is found that is free from interference.
Removing the remote’s panel to access its batteries and
channel selector switches. Adjusting the remote’s channel selector switches.
Removing the Integrator’s top panel to access its channel
selector switches. Adjusting the Integrator’s channel selector switches.
11