Tecma Compass High ECO Owner’s & Installation Manual
19
www.thetfordmarine.com
1. Caulk along inside of trace line.
2. Place
1
; insert
2
into floor; secure.
3. Caulk around
1
base.
Installation, Con’t.
Operation
Locate H position; cut hole.
AR
T00212-1
3-1/2” 1(x)
H
DANGER:
Failure to use a Vented
Loop in raw water pump installation sites can lead
to water flowing into the toilet from the outside
(siphoning) which can cause loss of property and
life! Refer to Installation Planning - “
Raw Water
Considerations”
to determine if a Vented Loop
is needed!
D
BEFORE permanently attaching the toilet:
■
Flush the toilet to check toilet operation.
■
Verify no leaks; correct as needed.
■
Permanently insert
K4
and
K5
into wall.
Test Toilet
Caution!
Seal with silicone or latex
base sealant. Do not use Polysulfide base seal-
ants that can damage plastic.
(2x)
2
1
8
10
11
12
Vertical Installation
Horizontal Installation
1. Choose installation method.
2. Run
H
; assemble parts as shown.
3.
Tighten 1-1/2” to secure in place.
1-1/2”
1-1/2“
9
T000001B
T000001B
E
3
4
H
3
4
H
The ECO Rocker switch has two operation modes : “Add Water” (before use) and “Flush “ (after use)
to be respectively activated by keeping pressed the upper or lower switch. The functions are clearly
indicated on the switch.
The “Add Water” function adds water in the bowl as long as the upper button is kept pressed. The
“Flush” function (after use) together activates the macerator pump and adds water inlet during the flush
as long as the lower button is kept pressed.
