Installation / Owner’s Manual 20
!
- Align the right edge of the lower intake vent with the right edge of the refrigerator cabinet as viewed from the rear.
3. Install the upper exhaust vent:
CAUTION:
Make sure that no sawdust, insulation, or other construction debris is on the refrigerator or in the enclosure.
Debris can cause a combustion hazard and prevent the refrigerator from operating correctly.
NOTE: Tighten the screws of the upper roof exhaust cap to 11.5kgf/cm. Also make sure that the air flow around the upper
roof exhaust cap is not blocked or decreased by other roof mounted features such as a luggage carrier, an air conditioner,
a solar panel, etc.
- If the design of the vehicle allows, install the roof exhaust vent [12] directly above the condenser [11] of the refrigerator (See
Art02264).
- Install a baffle [13] to prevent stagnant hot air in the area [14] above the refrigerator.
- Make sure there is less than 6mm clearance [15] between the baffle and the top of the refrigerator.
- Make sure the baffle is the full width of the inside of the enclosure.
- If the design of the vehicle does not allow you to install the roof exhaust vent directly above the condenser [11] of the refrigerator
(See Art02265).
- Align the roof exhaust vent [12] above the condenser [11] of the refrigerator and move it inboard as necessary.
- Install two baffles [13] to prevent stagnant hot air in the area [14] above the refrigerator.
- Make sure the baffles are the full width of the inside of the enclosure.
- Make sure that the baffles are no more than 45° from vertical [20].
- Put one baffle between the top rear edge of the refrigerator and the inside edge of the upper exhaust vent opening.
- Put the other baffle between the outside edge of the upper exhaust vent opening and the side wall of the vehicle.
- If the depth of the enclosure is 610mm or more and is less than 635mm, no baffles are necessary at the rear of the enclosure.
- If the depth of the enclosure is 635mm or more and is less than 660mm, add two baffles [16] to the rear of the enclosure (See
Art02264 and Art02265).
- Put one baffle 455mm to 470mm above the bottom of the enclosure [17] (205mm to 220mm above the top of the lower intake
vent opening REF) [18].
- Put the other baffle at the lowest edge of the condenser [11] of the refrigerator.
- Make sure that the baffles are
25mm or less [19] from the coils [10] and condenser of the refrigerator.
- Make sure that the baffles are the full width of the inside of the enclosure.
