Theta Digital Generation VIII Series 3, Руководство пользователя

Страница: 15 / 39

8
Remote Control
1.
Standby button. After the rear panel MAIN POWER
switch is turned on, press the front panel STANDBY
button to exit the standby mode. The Gen VIII will
quickly initialize. The VFD will default to the last
selected
INPUT . Pressing STANDBY again will
place the Generation VIII into standby mode and the
LED in the front panel
STANDBY button will light.
Each time the unit is put into standby, the VFD will
“exercise” itself for 10 seconds by illuminating all
pixels. (This will enhance the lifetime of the VFD).
The Standby button is inactive when the Generation
VIII is in
SETUP .
2.
Input Select buttons 1 through 5. Used to select a
desired INPUT , or to change a parameter when in a
submenu. The LED in the button lights when the
button is pressed.
3. The
DISPLAY button will cycle the VFD brightness
through full brightness, ¾, ½, ¼ and off.
4.
Mute button. Mutes/unmutes all audio outputs. Not
active when optional fixed volume cards are installed.
5.
Setup button. Used to enter/exit the SETUP menus,
when setting all user parameters.
6.
Level Up/Down buttons. Increases/decreases
master volume. Also used to increment/decrement
values in the
SETUP menus.
7.
Level Left/Right buttons. Shifts audio balance to
the left and right, or adjusts the master volume within
submenus when the
LEVEL UP / DOWN buttons are
used for parameter value editing.
8.
Phase button. Toggles the phase (0-180°) of all
speaker outputs.
Figure 5 - Remote Control
Note
: When operating the hand held remote control, point it at the remote sensor on the Generation VIII’s front panel. The
remote control can be used 3 to 20 feet from the Generation VIII and within a 30
o
angle from each side of the sensor.
Exposing the remote sensor to direct sunlight or strong light may cause faulty operation.