Theta Digital Generation VIII Series 3, Руководство пользователя

Страница: 12 / 39

5
Front Panel Layout
Figure 2 - Front Panel Layout
1. Remote IR receiver.
2. STANDBY button/LED. After the rear panel MAIN POWER switch is turned on, press the front panel STANDBY button to exit
the standby mode. The Generation VIII will quickly initialize. The VFD will default to the last selected INPUT . Pressing
STANDBY again will place the Generation VIII into standby mode and the LED in the front panel STANDBY button will light.
Each time the Generation VIII is put into standby, the VFD will “exercise” itself for 10 seconds by illuminating all pixels. (This
will enhance the lifetime of the VFD).
3. 24 character by 2 row Vacuum Florescent Display (VFD).
4. Buttons 1 through 5. Used to select a desired INPUT , or parameter to change in the SETUP menus. The LED in the button
lights when the button is pressed. These buttons are referred to as the INPUT SELECT buttons.
5. SETUP button. Used to access the SETUP menus, for setting all user parameters.
6. LOCK light. Lights when a valid digital signal is detected on the currently selected input.
7. MUTE button. Mutes/unmutes all audio outputs. Not active when optional fixed volume cards are installed.
8. LEVEL LEFT and RIGHT buttons. Shifts audio balance to the left and right, or adjusts the master volume within submenus
when the LEVEL UP / DOWN buttons are to be used for editing parameter values.
9.
The DISPLAY button will toggle the VFD brightness between off, ¼, ½, ¾ and full brightness.
10. LEVEL UP and DOWN buttons. Increases/decreases master volume. Also used to increment/decrement values in the
SETUP menus.