Theta Digital Casablanca III HD, Руководство пользователя, Страница: 78 / 106

78
Initial Power-On Master Volume
Button # 1 ( INILVL , or Initial Level) allows the user to store the initial master volume setting that the Casablanca III HD
defaults to out of standby.
FVOL and SVOL
When certain parameters are edited or the master volume changed, holding the LEVEL UP / DOWN button for more
than 5 steps will, by default, speed up the rate at which the value changes. This is referred to as Fast Mode . It is
possible to delay the speed of the Fast Mode to the user’s preference. On FVOL (Fast Volume – button # 2 ) a delay of
0 (0 milliseconds between steps) will set the Fast Mode to be its quickest, and a delay of 255 (255 milliseconds
between steps) sets it to be its slowest.
The response rate of the LEVEL UP / DOWN buttons during the first 5 steps is referred to as Slow Mode . Button # 3 -
SVOL allows the user to modify the speed of increment changes during these first 5 steps. In SVOL (Slow Volume) a
delay of 0 will set the Slow Mode to be its quickest, a delay of 255 sets it to be its slowest.
Maximum Overall Level
Button # 4 ( MAX ) allows the user to set a maximum master volume level. This is especially useful in a household
where young relentless children and smart pets have access to the system or the speakers are very efficient.
Changing the Default MUTE Level
The user can set the master volume level that the Casablanca III HD goes to when the front panel or hand-held remote
MUTE button is pressed. Editing this parameter is accessed by pressing button # 5 .
MUTE Off Trigger
The Casablanca III HD can be un-muted in 2 ways. Setting the parameter (accessed via button # 6 ) to MUTE allows
only the MUTE button to un-mute the Casablanca III HD. Setting this parameter to M+V ( MUTE and VOLUME ) allows
both the MUTE and LEVEL UP / DOWN buttons to un-mute.
Press the SETUP button once to return to the SETUP / GLOBAL page 1 submenu. Press the A-D button once to go to
the second GLOBAL page, shown in figure 54.
Figure 54 - Front Panel Display of the SETUP/GLOBAL page 2 Submenu
Cursor Type
When editing jack or input select names, the VFD character being edited can be indicated by blinking, a flashing cursor
below it, both, or no indication. This preference is set in the
SETUP / GLOBAL page 2 submenu, button # 1 .