Safety instructions
GBTT3LBA_V(3).DOC
Page - 9
2.4 Essential safety measures during normal operation
Failure to comply with the corresponding instructions can result in personal injury or damage to the printer.
Always comply with the following safety instructions to avoid personal injuries or
damage to the printer
•
The unit must only be used for printing labels, continuous paper and similar materials.
•
Only connect the unit to a power supply with suitable voltage. The unit is rated for AC voltage from 220 to
240 V. Only connect the printer to a grounded power socket.
•
Only connect the printer to devices with protective extra-low voltage.
•
Ensure that all units being connected (printer, computer, etc.) are switched off when connecting together.
Also switch the units off before disconnecting them.
•
Ensure that your printer is not exposed to any wet conditions.
•
The printer can be operated with the lid opened. In this condition, the rotating parts are freely accessible.
Ensure that no hair, jewellery etc. can get caught up in these rotating parts.
•
During operation, the print head component can get hot. Beware when touching the component.
•
The slits and openings of the housing and on the back and at the bottom are used for ventilation and must
not be blocked. Do not erect the printer in the vicinity of radiators or heat sources.
•
Always disconnect the power supply by removing the printer power plug. The socket must be close to the
printer and easily accessible.
•
Disconnect the printer from the power supply before starting any cleaning or maintenance work.
•
Only qualified maintenance technicians should repair the printer.
•
Damaged parts must be replaced.
•
The cutting unit must only be used when fitted to the printer.
Do not open the housing of the printer! Mortal risk from power supply voltage!
2.5 Fundamental safety measures during maintenance and service
Repair work on the electrical equipment of the machine may only be performed by a
specialist electrician!
Prior to performing any maintenance and repair work the machine must be switched
off and disconnected from the power supply!
