BOILER START-UP
21
7.3.
Fuel loading
The fuel must be loaded in the fuel tank and is then supplied to the pellet burner through the
pellet feeder. This is controlled directly by the pellet burner.
The first time the burner is started, the pellet feeder must be filled completely. This can take up
to 15 minutes, depending the length of the feeder and the rotation speed of the motor.
When adding fuel to the silo, be careful for any big woods, plastics or metal items not to enter
the silo. Such objects can block the pellet feeder or even damage it, and stop the burner
operation. Fuel can be added at any time while the boiler is in function.
Do not leave the silo to reach completely empty, because the feeder will empty and will need to
be filled again.
Do not load manually fuel to the burner directly! The burner loading must be done
only through the pellet feeder!
7.4.
Feeder filling procedure
1.
Remove the plastic tube connection the burner with the feeder
2.
Burner must be at stop mode. So, “Stop” appears on the LCD scree
3.
By pressing the button “MODE/ “ once changes the operation from “Stop” to “ignition”.
4.
“CHOICE FUNCTION-/+” appears on the LCD screen
5.
Press the button to start the feeder
6.
Feeders operation lasts 11min (Manufacturer's setting / Feeder's filling time"
7.
When the wood-pellet starts to come out of the feeder, press to stop the feeder
8.
Connect the feeder with the burner, by using the plastic pipe.
9.
If the "Feeder's filling time" is not enough, press to start the feeder again
7.5.
Operation mode
7.5.1.
Starting the burner
1.
Activate the burner by connecting it with a power supply (230Volt, 50Hz)
2.
It is written on the LCD screen the following
3.
By pressing the button “MODE/ “ once changes the operation from “Stop” to “ignition”.
By pressing the button “MODE/ “ changes the operation from “Ignition” to “Automatic”.
