14.
Restart the burner after an error
1. Turn off the burner by using the electric switch ON/OFF.
2. Open the boiler's door and check the burner tube.
3. Remove any ashes and impurities from burner fire chamber.
4. Close the door and switch on the controller by using the electric switch the burner is connected
5. By pressing the button “MODE/ “ once changes the operation from “Stop” to “ignition”.
By pressing the button “MODE/ “ changes the operation from “Ignition” to “Automatic"
15.
Feeder filling procedure
1.
Remove the plastic tube connection the burner with the feeder
2.
Reset the controller by pressing the ON/OFF button.
3.
“Stop” appears on the LCD scree
4.
By pressing the button “MODE/ “ once changes the operation from “
Stop
” to “
ignition
”.
5.
“CHOICE FUNCTION-/+”
appears on the LCD screen
6.
Press the button
to start the feeder
7.
Feeders operation lasts 11min (Manufacturer's setting / Feeder's filling time"
8.
When the wood-pellet starts to come out of the feeder, switch off the controller.
9.
Connect the feeder with the burner, by using the plastic pipe.
16.
Burner safety systems
For total, fail-safe security, the burner is equipped with four safety systems:
1. The plastic pipe connecting the feeder with the burner. This tube will melt away from the
burner in event of a too high temperature, thereby breaking contact between pellets fuel
replenishment and the burner.
2. The burner’s fall-tube is equipped with a back-burn protection system which is triggered at
65
o
C. The back-fire protection system is placed on the fall-tube. In the event of the alarm being
triggered always investigate the cause and rectify.
3. The Overheating Boiler sensor (STB sensor), which is activated when the boiler's temperature
is higher than 95
o
C. When this protection is activated, the light next to the STB sensor is ON and
the feeder is turned off. The, you must reset the STB sensor, the feeder to work again.
4. The photo sensor senses that ignition has taken place and is running normally.
