ThermoSpas Atlantis Genesis 200, Руководство пользователя

Страница: 26 / 56

20
Operating Instructions
Setting the Temperature
The LCD screen will constantly display the current water temperature, unless there is an
error code or the spa needs attention. To set the desired water temperature:
1. Press the Warm/Cool ( ) button, Figure 1. The current set temperature.
2.
Pressing the button a second time and any successive time will cause the set
temperature to increase or decrease depending on what direction was last chosen.
3.
If the opposite direction is desired, release the button and let the display revert to
the actual water temperature.
Then continually press the button to adjust the set
temperature.
Each time the panel reverts to the actual water temperature, the Warm/Cool button will toggle
between increasing and decreasing the set temperature. Anytime the spa is heating, the heater
indicator will be lit, Figure 2.
Note: Minimum set temperature is 59°F. Maximum set temperature is 104°F.
Jets Pump 1
Jets Pump 1 is a 2-speed pump. To operate Jets Pump 1:
1. Press Jets Pump 1 (
1
) button once to activate low speed, Figure 3. The Jets
Pump 1 indicator light will flash to indicate Jets Pump 1 low speed is active,
Figure 4.
Note: Pump 1 will automatically turn off after 20 minutes. You can press the Jets
Pump 1 button again to reactive the pump.
2. Press Jets Pump 1 (
1
) button again to activate high speed. The Jets
Pump 1 indicator light will be solid to indicate Jets Pump 1 high speed is active.
Note: Pump 1 will automatically turn off after 20 minutes. You can press the Jets Pump 1 button
twice to reactive the pump in high speed.
3. Press Jets Pump 1 (
1
) button a third time to turn the pump off. The Jets Pump 1 indicator
light will turn off.
4. Refer to “Automatic Functions” (page 19), for automated pump functions.
Jets Pump 2 (if equipped)
Jets pump 2 is a 1-speed pump. To operate Jets pump 2:
1. Press Jets Pump 2 ( 2 ) button once to turn the pump on, Figure 5. The Jets
Pump 2 indicator light will turn on to indicate jets pump 2 is active, Figure 6.
Note: Pump 2 will automatically turn off after 20 minutes. You can press the Jets
Pump 2 button again to reactive the pump.
2. Press Jets Pump 2 (
2
) button a second time to turn the pump off. The Jets
Pump 2 indicator light will turn off.
3. Refer to “Automatic Functions” (page 19), for automated pump functions.
Lights
The underwater light is turned on or off by pressing the light button, Figure 7. When
turned on, the light indicator light is lit, Figure 8. By turning the LED lights on and off,
you can cycle through the colors and effects.
Note: The lights will automatically turn off after 2 hours.
Figure 1
Figure 2
Figure 3
1
1
Figure 4
Figure 5
Figure 6
2
2
Figure 7
Figure 8
Operating Instructions