CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
DANGER
• NEVER store a spare cylinder under or near the
appliance or in an enclosed area.
• Never fill a cylinder beyond 80% full.
• An overfilled or improperly stored cyclinder is a hazard
due to possible gas release from the safety relief valve.
This could cause an intense fire with risk of property
damage, serious injury or death.
• If you see, smell or hear gas escaping, immediately get
away from the LP cylinder/appliance and call your fire
department.
Safety Tips
s
The use of alcohol, prescription or nonprescription drugs
may impair the consumer’s ability to properly assemble or
safely operate the appliance.
s
When grill is not in use, disconnect 1 lb. cylinder.
s
Never move grill while in operation or still hot. Allow the
appliance to cool before moving or storing.
s
Use only tools supplied or plastic tools.
s
Maximum load for side shelves is 10 lbs.
s
The regulator may make a humming or whistling noise
during operation. This will not affect safety or use of grill.
s
If you have a grill problem see the Troubleshooting Section.
s
Light burners. Check to make sure they are lit, close the lid
and warm up grill on high for 10 minutes. Curing of paint
and parts will produce an odor only on first lighting.
s
Grill is not to be used as a heater.
s
Clean grill often, preferably after each cookout. If a bristle
brush is used to clean any of the grill cooking surfaces,
ensure no loose bristles remain on cooking surfaces prior to
grilling. It is not recommended to clean cooking surfaces
while grill is hot.
Ignitor Lighting
s
Do not lean over grill while lighting.
1. Open lid during lighting.
Make sure LP cylinder is properly
connected to regulator.
2.
Turn LEFT knob to IGNITE.
3.
Turn rotary ignitor knob (up to 5 times) to light. Be sure
burner lights and stays lit.
4.
If ignition does NOT occur in 5 seconds, turn the burner
controls OFF, wait 5 minutes and repeat the lighting
procedure.
5.
To ignite RIGHT burner, turn right knob to IGNITE and repeat
steps 3-4.
6.
If IGNITOR does not work, follow match lighting instructions.
After Lighting: Turn knobs to HI position for warm-up. Do not
warm up grill with knobs on IGNITE. Knobs and handle will
become uncomfortably hot if left in IGNITE positions.
Match Lighting
1.
2. Insert lit match into match lighting hole. Turn gas on for
appropriate burner. Repeat on other burner.
Attach match to match lighting stick, light match.
Turn controls OFF and disconnect cylinder when not
in use.
WARNING
Match
Lighting
Hole
Match
Lighting
Hole
Back of grill
Match
lighting
stick
Normal
Hose
Kinked
Hose
Before Your First Cookout.
Leak test your grill.
Light burners, check to make sure they are
lit, close the lid and warm up grill on HIGH for 10 minutes. Curing
of paint and parts will produce an odor only on first lighting.
Turning Grill Off
• Turn knobs to OFF position. Make sure knobs pop up. If it
does not, discontinue use and order new part.
• Disconnect 1 lb. Cylinder.
Hose Check
•
Before each use, check to see if
hoses are cut, worn or kinked.
Replace damaged hoses before
using grill. Use only
valve/hose/regulator specified by
manufacturer.
6
Содержание GRILL2GO Advantage 07401407
Страница 1: ...07401407 80008949 05 23 08 ...
Страница 25: ......
