User’s manual
User’s manual
GB
71
Press the
left or
right scroll buttons
several times to
activate Prog mode,
until the selection
arrow is on Prog
mode.
OK
The
mode selection arrow blinks
above the currently selected mode.
4.1.5 - Automatic ventilation / Presence detection (Sweetcontrol)
The automatic ventilation and presence detection functions may be activated or deactivated
regardless of the chosen heating mode (Comfort, Eco, Weekly Prog or Prog FP) ; see page
61 for the action.
5 - LOAD SHEDDING
A load shedding system by a power supply cut is incompatible with our radiators because
it damages the thermostat. During load shedding periods, your radiator will display « Load
shedding ». It then returns to its initial operating mode.
6 - MAINTENANCE
Do not perform any maintenance action before switching your equipment off by doing a
long press on the
button.
If you want to maintain the performances of your radiator, you will need to use a vacuum
cleaner or a brush to remove dust from the lower and upper radiator grills about twice
every year.
You can clean the radiator with a damp cloth; never use abrasive products or solvents.
Dirt can accumulate on the radiator grill in a polluted environment. This phenomenon is
related to the poor quality of ambient air. It is recommended that correct aeration of the
room (ventilation, air intake, etc.), and cleanliness of the air should be verified if this arises.
Such dirt will invalidate the radiator replacement guarantee.
7 - IF A PROBLEM OCCURS
Problem encountered
Check to be made
The radiator does not
heat
If you are in programming, make sure that the program is in
COMFORT mode.
Make sure that the circuit breakers of the installation are
closed or that the load shedder (if you have one) has not
switched the heating off (see part X).
Check the air temperature in the room; if it is higher than
the set temperature, the heating pictogram will not come on
and the radiator will not heat.
The radiator heats all
the time
Check that the radiator is not located in a draft, and that the
temperature setting has not been modified.
The radiator does not
heat enough
Increase the Comfort set temperature.
If the setting is at the maximum, make the following checks:
-Check if there is another heating source in the room
- Make sure that your radiator is only heating the room (door
closed).
- Have the radiator power supply voltage checked.
- Check if the power of your radiator is appropriate for the
size of your room (we recommend about 100W/m
2
for a
ceiling height of 2.50 m).
Traces of dirt collect
on the wall around the
radiator
Dirt is caused by poor quality of ambient air. In this case, it
is recommended that good aeration of the room (ventilation,
air inlet, etc.), and cleanliness of the air should be checked,
and do not smoke indoors. This dirt does not justify
replacement of the radiator under guarantee.
The heating pictogram
is displayed on the
screen when the
radiator is in ECO
mode
This operation is normal. The radiator can warm up so as to
maintain an Eco temperature.
For radiators equipped with a programming system or controlled through the pilot
wire.
The radiator does
not follow external
programming controls
Make sure that the programming control unit is used
correctly (see user’s instructions), that the programming unit
is properly engaged in its housing and that it is functioning
normally (check the condition of the batteries, fuse, etc. ).
Make sure that your radiator is in Program mode and that
the external « centralised » program is assigned to the
required day of the week.
Equateur2_1880-1585_interieur.indd 71
18/06/12 06:22
Содержание R4GHD2-Mk22
Страница 48: ...46 Manuel d utilisation FR...
Страница 94: ...User s manual GB 92...
