14
The device you have just purchased was submitted to many tests and checks ensuring its quality.
We thank you for your choice and trust.We hope you will be fully satisfied.
A few recommendations:
Read the instructions before installing the device.
Power the device off before intervening on it, and check the power supply voltage.
Store the instructions, even after installing the device.
Characteristics of the device:
(
shown on the machine’s information label
)
Cat C
: Complies with EU standards for this category.
IP24
: Protected against water projections.
Classe II
: Dual insulation.
I
NSTALLING THE DEVICE
1) Location of the device
- This device was designed to be installed in resi-
dential premises. In any other case, please call
your distributor.
- Installation must comply with the standards cur-
rently enforced in the country of use.
- Locate the heater within minimum distances
from obstacles.
Do not install the device :
•
In a draft likely to affect its control (
under cen-
tralised mechanical ventilation, etc…
).
•
Under a fixed mains outlet.
•
Inside zones 0 and 1 in bathrooms.
The device is to be installed so that switches and
other controls cannot be touched by a person in
the bath or shower, except in the UK where IEE
Regulations 701.512.2 and 701.512.3 apply. These
allow the use of IP24 rated products and their
integral controls in Zone 2 and ouside zones.
150 mm mini
200 mm mini
150 mm mini
L
H
Volume
3
Volume
2
60 cm
60 cm
60
cm
3 m
2,25
m
Volume
1
