-10-
-11-
EN
EN
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Reorient or relocate the receiving antenna.
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Consult the dealer or an experienced radio/TV technician for help.
7. Do not use stainless steel probes in a microwave oven.
8. The Probe Thermometer registers temperatures as low as 14 ºF (-10 C) and
as high as 572 ºF (300 ºC). Do not use the stainless probe sensor above
572 ºF. Doing so will deteriorate the wire.
º
9. Not Intended for use by persons aged 12 and under.
18. Cleaning
Always wear heat resistant glove to touch the stainless steel probe sensor
or wire during or just after cooking. Do not touch with bare hands.
Keep the stainless steel probe sensor and wire away from children.
Wash the metal probe tip with hot soapy water and dry thoroughly. Do not
immerse the probe in water while cleaning
Wipe the transmitter and receiver with damp cloth. Do not immerse either in
water.
the transmitter to water or any liquid. This will result in a bad connection and
faulty readings.
5. Wipe the transmitter and receiver with damp cloth.
6. Do not expose the receiver or transmitter to direct heat.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
3. Clean the stainless-steel probes and dry thoroughly after each use.
4. Do not expose the plugs of the stainless-steel probes or the probe sockets of
2. Keep the stainless-steel probe sensors and wires away from children.
19. FCC Compliance
Information to user
Warning:
Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the users' authority to operate the
equipment.
Note:
This equipment has been tested and found to comply with the limits for
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
a
However, there is no guarantee that interference will not occur in a particular
20. Declaration of Conformity
Hereby, the manufacturer declares that this product complies with the basic
requirements and applicable regulations of the Radio Equipment Directive
2014/53/EU, the EMC Directive 2014/30/EU. The complete declaration of
conformity can be found at:
https://itronicsmall.com/eu-declaration-of-conformity/
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
21. Disposal
Meaning of the “Dustbin” Symbol
Protect our environment: do not
equipment in the domestic waste.
dispose of electrical
Please return any electrical
use to the collection points provided for their disposal.
equipment that you will no longer
or wires during or just after cooking. Do not touch with bare hands.
