11 Synchronize Remote Sensors with The Base Station
1. Place the remote sensor near the base station.
2. Insert the batteries into the base station, the RF indicator (located on the
upper left of the outdoor temperature display section) will begin to flash for
3 minutes, indicating that the base station is in synchronization mode and
waiting for remote sensors to be registered.
3. Set the CHANNEL selector (on the back of the remote sensor unit) to position
1 or 2 or 3. The unit is pre-set to Channel 1 and you can always leave it
unchanged unless you have purchased more than 1 remote sensor.
4. Press and hold ON/OFF button on the back of the remote sensor for 2 seconds
to turn on the remote sensor. Then wait for a moment until the temperature of
the remote sensor is displayed on the base station which indicates the
synchronization is complete.
5. If the synchronization is not successful after 3 minutes since the batteries
were inserted into the base station and the RF indicator no longer flashes,
press and hold the CHANNEL button on the back of the base station for 3-4
seconds until the RF indicator begins to flash again, setting it back into
synchronization mode;
6. If you have additional remote sensors, repeat the above steps to synchronize
the additional remote sensors (up to 3 remote sensors can be registered with
one base station). Please note the additional sensors should be set to a
different channel.
7. If you have registered more than one sensor, press the CHANNEL button on
the base station to select the remote channel you want displayed permanently
12 Thermometer
1.
Once the remote sensor and the base station are synchronized, the indoor
temperature/humidity and outdoor temperature will both be shown the base
station display.
2.
Maximum & Minimum Recorded Temperature & Humidity
a. Press MAX/MIN/CLEAR button once to display the highest indoor
temperatures/humidity and outdoor temperatures recorded. MAX is
shown on the display.
b. Press MAX/MIN/CLEAR button again to display the lowest indoor
temperatures/humidity and outdoor temperatures recorded. MIN is shown
on the display.
c. To clear and reset the max/min records, press and hold MAX/MIN/Clear
for 3 seconds.
3. Temperature and Humidity Trend: there are 3 types of icon on the base
station display:
indicates the temperature and humidity are in an increasing trend.
indicates the temperature and humidity are in a no change trend.
indicates the temperature and humidity are in a decreasing trend.
13 Barometer
1. Press the HISTORY button on the back of the base station to show the actual
barometric pressure value in the past 1 to 12 hours.
2. Barometric Pressure Trend: on the bottom of the display, the graph shows
the barometric pressure change in the last 12 hours.
-6-
-7-
EN
EN
10 Display Unit Selection
1. Press °C/°F button on the back of the base station to change the temperature
display unit between °C or °F.
2. Press inHg/mb button on the back of the base station to change the
barometric pressure display unit between inHg or mb (hPa).
on the base station. If wanting to observe all channels, press the CHANNEL
button until you observe a circular arrow on the base station LCD display
under the channel number, the unit will auto-scroll, changing from channel to
channel every 5 seconds.
