48
Operating instructions BW3-CTMC + BW3-RF
© 2011 by Thermoplan, subject to change
2 General notes
2.6 Installation
2.5 Rating plate
2.7 Cleaning
2.8 Electrical connection
Make sure that there is enough space next to the Black&White3 coffee machine for the refrigerator. Have the
refrigerator connected to the Black&White3 by trained service staff.
The refrigeration system must be sufficiently ventilated. To do so, make sure that there is enough space on the free
side of the refrigerator (opposite side to the Black&White3) for the air to circulate. Make sure that there is a gap
of at least 50cm on the refrigerator side.
The refrigerator must be connected to a Black&White3 machine (models CTM, CTMS, CBTM or CTMC) and must
not be used separately.
The rating plate is on the side behind the drip tray of the refrigerator and includes the following information about
the refrigerator:
- Equipment type (Refrigerator)
- Voltage (220 - 240 VAC)
- Model (Model)
- Frequency (50/60 Hz)
- Internal capacity (Volume)
- Current (0.75 - 0.85 A)
- Cooling agent (Refrigerant)
- Serial number (S/N)
- Cooling agent quantity (Charge)
- Date of manufacture (Prod. Date)
- Insulation gas (1,1,1,3,3-Pentafluorpropane)
Clean the refrigerator daily.
Make sure the refrigerator is disconnected from the mains before cleaning it.
Clean the outside of the refrigerator using a cloth and lukewarm water and dry it using a soft cloth.
To clean the inside, use a cloth and lukewarm soda water or vinegar and water and then dry it using a soft cloth.
This device complies with EC standard 89/336 in terms of radio interference suppression. Before connecting the
machine, make sure that the mains supply corresponds to the voltage indicated on the rating plate.
The refrigerator must be wired in accordance with the legal requirements. Ensure that the electrical equipment is
wired according to directions. In the event of personal injury or damage to property, the manufacturer assumes
no liability if these have been caused by failure to comply with the regulations.
Do not use any adapters, multiple plug or extension lead for the connection. If this cannot be avoided, only use
equipment which complies with the relevant safety regulations and does not in any way exceed the specified
current-carrying capacity limits.
If the plug and socket do not match, replace the socket with a suitable socket. This should only be done by qualified
personnel. Ensure that the cable cross-section of the socket is adapted for the power input of the device.
