6
8-11-12
EXPLANATION OF CONTROLS
The controls are located in a control enclosure above the heating element and pump
housing assembly.
MAIN SWITCH
This is a combination power switch and circuit breaker, when pressed this switch
allows power to be supplied to the controls and the pump circulating motor.
Incorporated in the face of the switch is a ’MAINS ON’ indicating light.
CAUTION:
The equipment is fitted with a combination circuit
breaker, mains switch. If the circuit breaker continues to trip, it
may indicate an electrical fault exists. Switch Off the power and
consult a qualified technician.
The temperature range is +30°C to +100°C (A5°C) Model TU-1. The desired
operating temperature is set at the control knob against the scale which is graduated
at 2°C increments. The control is factory calibrated.
Maximum recommended temperature is 100°C (Equipment Dependant).
ELECTRICAL - POWER LEAD
A removable mains power lead with a three pin plug and right angle female IEC
socket is supplied for connection between the male IEC socket located at the rear of
the incubator (top left side) and a ten (10) Amp General Purpose Outlet (G.P.O.)
Caution:
Should the circuit breaker continue to
trip, switch off the power and consult a qualified
technician.
Main Switch
Heat cycle
indicator
Temperature
control knob
