THERMODYNE 742HW, Руководство по установке и эксплуатации

Страница: 9 / 20

— 9 —
Before installing, verify the required electrical
supply agrees with the specifications on the data
plate located on the back or side of the unit. If
the supply and equipment requirements do not
agree, do not proceed with installation. Contact
your dealer or Thermodyne Foodservice Products,
Inc. immediately.
CAUTION: These models have glass doors.
Remove carton carefully.
1. Allow ample overhead clearance for removal
of carton.
2. Cut banding (2 pieces) and remove nails (not
for all units).
3. To remove cabinet from carton, slide carton
up and off the cabinet.
4. Check packing list against items received:
A. Thermodyne Heat Transfer Fluid
B. Installation & Operation Manual
5. Use proper lifting equipment to raise the
cabinet.
6. Remove the plastic covering from glass door
frames and hinges.
7. Mount doors on cabinet, and then check doors
for alignment.
8. Set cabinet on a level surface.
LOCATION
Allow adequate space for electrical connections.
The electrical cord and plug are located at the right
rear of the unit. The minimum clearance for proper
air circulation on back should be 4”, and 2” on at
least one side. Allow adequate access space for
operating and servicing the unit.
NOTICE: Louvers on the sides of the oven
are used to circulate cool air throughout the
electrical components. The unit must not be
placed where extensive airborne grease is
present, such as near deep fryers or griddles.
ELECTRICAL CONNECTION
: Electrical and grounding
connections must comply with applicable
portions of the National Electrical Code and/
or other local electrical codes.
: Disconnect the electrical
power to the Thermodyne unit and follow
LOCKOUT/TAGOUT procedures.
Refer to the wiring diagrams in this manual for
wiring information.
MODEL VOLTS AMPS WATTS HERTZ PHASE PLUG
742HW 208/240 22/23 4730/5500 60 1 NEMA 14-30
744HW* 208/240 25/27 5250/7000 60 1 NEMA 14-30
208/240 15/17 3440/4000 60 1 NEMA 6-30
742HW-CT 208/240 8/9 1770/2000 60 1 NEMA 6-30
744HW-CT 208/240 15/17 3440/4000 60 1 NEMA 6-30
742HW-CT (6in) 208/240 8/9 1540/2040 60 1 NEMA 6-15
744HW-CT (6in) 208/240 15/17 3120/4080 60 1 NEMA 6-30
* Two (2) plugs required for this unit.
ELECTRICAL SPECIFICATIONS
INSTALLATION