— 9 —
Set-Up
1. Press the “Up” and “Down” key as needed to
adjust the displayed set-point temperature.
2. The “OUTPUT1” LED will be lit up solid during
warm up. (normal operation)
3. When the “OUTPUT1” LED is blinking, the unit
has reached the desired temperature.
NOTE: This controller is not an indicator of fluid
level in the Heater or Reservoir Tanks.
To Toggle Between °F and °C Readout:
1. Press the “Scroll” key 2 -3 times until the upper
display reads: “unit”.
2. Press the “Up” or “Down” key to choose.
Preheating
Preheat the Thermodyne cabinet when first used
for the day or whenever the unit is cold. Preheating
takes approximately 30 minutes at which time the
temperature set point and the actual temperature
will display the same temperature. If the unit
has wells, keep the pans in the wells during the
preheat cycle.
