Thermocet Trimline 2050 OH, Инструкции по эксплуатации и монтажу

Страница: 16 / 40

Page 16
Do
not
extend the thermocouple supplied to the pilot set
Extending the thermocouple beyond its limit will lead to a reduction in voltage. This may, in turn, lead to
the magnetic coil not being activated.
Do
not
extend the thermocouple supplied to the pilot set
Extending the thermocouple beyond its limit will lead to a reduction in voltage. This may, in turn, lead to
the magnetic coil not being activated.
The receiver and the control units on the gas control block should be switched on to ensure automatic
start-up through the manual transmitter.
The oval disk on the gas control block should be turned to the ON position. The 1/0 switch should be set to
1. See photograph 2. The ignition cable should be connected to the SPARK connection point on the
receiver box. See photograph 1.
The manual transmitter has to communicate with the receiver. This has to be ‘learnt’.
Press the RESET button using a blunt object. (See photograph 3.) Continue to press this button until you
hear a short beeping sound, followed immediately by a long beeping signal. Release the button. Direct the
manual transmitter towards the receiver and press the arrow down until you hear a long beeping sound. The
gas control button will now move for a short period.
The manual transmitter has now learned the setting with regard to the receiver and the unit can now be
ignited using the remote control. If the manual transmitter is still not communicating with the receiver,
repeat the procedure again.
The system’s thermostat sensor is in the manual transmitter.
The manual transmitter operates best at a distance of 2 or 3 metres from the unit. Although communication
occurs via short wave radio signals, it is recommended to place the hand transmitter in view of the gas
apparatus in a place where the user wishes to experience a pleasant temperature. Do
not
place the manual
transmitter in direct sunlight or other warm location. The thermostat measures the temperature and
regulates the flame size of the gas unit accordingly
.
Remove the batteries only with the red ribbon underneath the batteries,
not with a metal
tool
Removing batteries with a metal object may damage the electronic control permanently.
Photo 2
Photo 3
Photo 1
40 mm