CUTTING TO SIZE INSTRUCTIONS:
The soles are constructed in such a way, that the size can be trimmed to fit if need-
ed! Please be sure to follow the
WARNING
statement printed on the bottom of the
soles! The two cutting lines are for reference only! Please note that the
THERMO
SOLES
cannot be exchanged, if they were trimmed.
CAUTION
–
Do not cut beyond the solid line or excessively bend the soles!
This will cause damage to the heating elements and the product!
CARE INSTRUCTIONS:
•
Turn OFF the soles when not in use.
•
Store the soles and adapter in a clean and dry place.
•
Only use the enclosed original adapter to charge the soles.
•
Only charge the soles when they are outside of your shoes or boots.
•
Do not damage the heating elements by bending the soles.
•
Cut the soles to size only as mentioned above!
•
Clean with a damp cloth only!
•
Do not submerge in water!
•
Air-dry the soles only! Do not place them on radiators or any other hot surface!
•
Let the soles dry completely before charging again.
•
The switch must be set to the “OFF” position when charging the soles.
•
Should the switch be set to the “ON” position when charging, the soles will NOT
be charged! In this case, please disconnect the soles from the adapter cables,
turn the switch a couple of times to the “ON/OFF” position and then set it to
“OFF” before connecting the soles to the adapter cables again.
The temperatures are measured directly at the heating elements.
HELPFUL INFORMATION
Please perform the following test in case you feel that the soles are not heating
correctly:
– Charge the soles completely (switch to the left!)
– Both soles always must be charged at the same time!
– Now turn ON the soles (switch to the right!) and the LED light on the soles will
light up!
– Place the soles in the refrigerator for about 5 – 10 minutes.
– Check the LED lights of both soles after taking them out of the refrigerator again.
– If the light is ON, then the soles are in the heating mode and you should feel
the warmth on the upper and lower sides of the soles with your hands or your
cheek.
– The LED lights will turn off again after about 2 minutes. (As explained above!)
DISCARDING OF THE SOLES
Discard
THERMO SOLES
with approved collection agencies only! In order to save
our environment, do not dispose the soles in your normal household trash.
To remove the batteries from the soles, we recommend proceeding as follows:
– Hold the heel of the soles and pull the tab below the ON/OFF switch down.
– This will separate the bottom black fabric lining from the top portion of the soles.
– You will notice the electronic portion, which is connected to the battery by two
cables.
– Cut the two cables and remove the battery from the soles.
– Discard the batteries separately from the soles.
Please note, that by removing the batteries from the soles, your
THERMO SOLES
will be irreversibly destroyed!
RoHS
Compliant
2002/95/EC
