Thermo Scientific VT 6060 M-BL, Руководство по эксплуатации

Страница: 28 / 45

28/45 50041981 J
4. SETUP AND INSTALLATION
Apart from the instructions in this manual, the respective national laws, regulations and
guidelines must also be observed for the installation and Operation of this unit
TRANSPORT
Handle the unit with care. Avoid jarring and protect against damage. Do not lift / carry by the door
handle or the door itself.
Refer to the TECHNICAL DATA for dimensions and weight.
UNPACKING
Unpack the unit, take the accessories out of the inner chamber and remove any dust or dirt which
may have accumulated in transit.
INSTALLATION
Place the laboratory vacuum drying oven an a firm fireproof surface (e.g. laboratory table, support
frame, ...) in a stable, perfectly upright position.
The vacuum drying cabinets of the VT 6…M - BL series may not be stacked on top of one anoth-
er.
The ambient temperature of the unit at its installation location should not exceed 40 °C .
The unit must be installed in a dry environment.
At altitudes up to 300 m above sea level or other conditions, which may affect the ambient air
pressure, it is possible that the heater of the equipment is not switching-on.
If the site is changed in terms of height the equipment must be adjusted by an authorized service
organization.
Do not cover or obstruct the ventilation or exhaust vents in the unit housing.
The unit must not be installed or operated in enclosed areas without ventilation .
UNDER-TABLE INSTALLATION:
Units of the VT 6…M - BL series are not suitable for this type of installation , and must not be fit-
ted under laboratory tables for reasons related to explosion protection.
MOBILE SUPPORT FRAMES:
If the oven is mounted on a mobile support frame to enable the flexible utilization of this equipment
throughout the laboratory, make sure that the support frame is equipped with lockable castors.
When the oven is moved to a new location, make sure that the castors have been locked.
If the oven is used in several different locations within the laboratory, particular care must be taken
to ensure that the electrical Gables and gas vacuum lines are not damaged.