Thermo Scientific Vanquish Charger, Руководство по эксплуатации

Страница: 53 / 88

6 • Operation
Vanquish Charger Operating Manual Page 53
6.5 Important Settings for Operation
The parameters described in this section should be considered for
routine operation of the Charger. You can access these parameters from
the Chromeleon user interface. For more information, refer to
Chromeleon Help and documents
.
Setting Description
Temperature Control
On/Off Activate and deactivate temperature control inside the
compartment.
Nominal Temperature The target temperature for the autosampler and
Charger compartments. Setting a nominal
temperature automatically turns on temperature
control.
Ready Temperature Delta The maximum allowed deviation between the nominal
temperature and the actual temperature. If the
temperature deviates from the nominal temperature
by more than the maximum allowed deviation, the
Charger is not ready to operate. If set to
None ,
Chromeleon does not check whether the nominal
temperature deviates from the actual temperature.
Reset Temperature History Resets the temperature history. The temperature
history logs minimum and maximum temperatures of
the Charger compartment since the last reset.
Rack Type CHXX Indicates the type of the sample rack or well plate that
is located at level # 1 (
RackType_CH01 ) to level
# 20 (
RackType_CH20
), as recognized during rack
identification. If the indicated rack type is Unknown ,
select the correct rack type from the list.
If no sample rack or well plate is installed in the
respective level, the rack type is displayed as
Empty
.
Sample Position The sample position identifies the position from which
the autosampler needle draws the sample. It consists
of the Charger level number and the position on the
sample rack or well plate (for example,
CH01:E8 ).
Light Mode Determines the behavior of the compartment light. In
automatic mode, the light is dimmed when the door is
closed, and on when the door is open. You can select
whether to always have the light dimmed, on, or off.
Reset Resets the internal Charger and autosampler control
information. This may be required, for example, if a
rack had to be removed manually from segment Y.