44 / 94
Operation
3. 2. Power on / off
3. 2. 1. To power on the centrifuge
Push on the mains switch of the centrifuge to “1” to power it on.
The centrifuge shows the actual value in the display. Speed and Time show 0. The display
shows the current temperature of the sample.
3. 2. 2. To power off the centrifuge
Set the mains switch of the centrifuge to “0” to power it off.
NOTICE
The centrifuge is equipped with a special switch for balancing potential voltage
discrepancies in the power grid. After pressing the mains switch the display therefore may still
flash up to 10 seconds.
3. 2. 3. Audible Alarm
Error
Accompanying all error messages, a warning signal is given out.
Press any key to silence the warning signal.
End of Run
By default there is an acoustic signal at the end of any centrifugation run. To switch off this
signal proceed as follows:
1. Keep the
TOGGLE
button pressed when you turn on the centrifuge.
The display shows:
or
2. Press the up and down
ARROW
buttons
under the TIME display in the middle.
