14 | Emerald Bluetooth Enabled Wireless Remote Sensors
Compatible Sensors for Smart-Vue Pro Duo / Quatro Data Logger
5. Wait until the unpairing process is complete which may
take a few seconds then tap
OK
. The wireless remote
sensor is removed from the list.
Resetting a Wireless Remote
Sensor’s Battery Counter
To reset the Emerald wireless remote sensor’s battery
counter (only after removing or replacing batteries), use the
Reset battery option on your Smart-Vue Pro data logger.
To reset the wireless remote sensor’s battery counter:
1. Tap the menu icon
Sensors
Remote sensors.
2. Enter your PIN code and tap
OK
.
3. Tap Reset battery.
4. Sensors that are currently paired with the Smart-Vue Pro
data logger are displayed. Tap to select the serial number
of the sensor whose battery you have changed and wish
to reset.
Figure 11. Resetting a wireless remote sensor’s
battery counter
5. Tap
OK
to confirm that you want to reset the battery
counter.
6. Tap again on
OK
to return to the remote sensors menu
when done.
Swapping Sensors
The purpose of the Smart-Vue Pro Swap sensor feature is to
replace a Bluetooth wireless remote sensors while it is
currently being used for data logging.
Wired Sensors
With your Smart-Vue Pro data logger, you may directly swap
wired sensors that are physically connected to your data
logger such as for recalibration or to replace damaged cables.
Wired sensors may be replaced at any time whether data
logging is running or not. You must ensure that the existing
and replacement sensors are identical in type.
The process is completely transparent and guarantees
continuity while avoiding down-time or interruptions.
Emerald Wireless Remote Sensors
With wireless remote sensors connected via Bluetooth, you
must use the Smart-Vue Pro data logger interface to swap
wireless remote sensors. To do this, the following conditions
must be met:
•
Data logging must be currently running using the wireless
remote sensor you want to replace.
•
The new wireless remote sensor must also be paired with
the Smart-Vue Pro data logger (up to four remote
sensors may be paired with Quatro data logger).
•
The two wireless remote sensors must be of the same
type.
For example, both must be the same type of Emerald
internal or external (with Pt100 probe) sensor.
Note:
When Four (4) maximum wireless remote sensors are
paired with the Smart-Vue Pro data logger, data logging
needs to be stopped for at least one wireless remote sensor
in order to use the swap functionality.
To swap sensors:
1. Tap the menu icon
Sensors
Remote sensors.
2. Enter your PIN code and tap
OK
.
3. Tap
Swap sensor
.
4. Tap to select the sensor to replace and tap
OK
to
confirm.
CAUTION:
Only perform this action if you actually
install a new battery in your Emerald wireless
remote sensor module.
CAUTION:
The above instructions only affect the
battery contained in Emerald wireless remote
sensors, not the Smart-Vue Pro data logger itself.
