Thermo Scientific BF51728, Инструкция по установке и эксплуатации

Страница: 52 / 81

1100°C Box Furnace 330985H01 | 6-51
Main Controller: 1x8 & 5x16 Segment Programmable |
Chapter 6
4. To set the ramp unit, press SCROLL button to select ‘RAMP.U’ and then
press DOWN or UP button to select hour, min or sec (In this example
the ramp unit is set in min).
5. To set the Dwell unit, press SCROLL button to select ‘DWEL.U’ and then
Press or to select hour or min (In this example the dwell unit is set in
min).
6. To set the first Target Set point, press SCROLL button to select ‘TSP.1’ . Then
Press DOWN or UP button to set the value.
7. To set the first Ramp rate, press SCROLL button to select ‘RMP.1’ . Press
DOWN or UP button to set the value.
8. To set the first Dwell, press SCROLL button to select ‘DWEL.1’ . Press DOWN
or UP button to set the value.
9. Now repeat the above three steps (6, 7 & 8) to set remaining all segments.
NOTE

If not all the segments are used for a program, the Ramp & Dwell of each of the
subsequent Segments should be set to OFF.

A program will end in one of two ways, either revert to the control Set Point or
dwell at the temperature set in the last segment used. When a program finishes
on a dwell and the dwell time expires the temperature will revert to the control set
point.

Before running a program ensure that the control set point is set to Zero to avoid
unexpected heating at the end of the program.

When a Holdback is set, each segment used must have a Ramp Rate assigned to
it, in order for it to be recognized by the program.