Thermo Scientific AquaSensors
™
AnalogPlus
™
Contacting Conductivity Sensor User Guide
5
1.2.
Intended use
The Thermo Scientific AquaSensors AnalogPlus 1.0 inch Contacting Conductivity sensor is designed to
continuously measure Conductivity/Resistivity and temperature in aqueous solutions in accordance with the
technical product specifications in Section 2.2 of this manual.
Any other use, or use not mentioned here, that is incompatible with the technical specifications is deemed
inappropriate. The operator is solely responsible for any damage arising from such use.
Other prerequisites for appropriate use include:
•
Observing the instructions, notes and requirements set out in this instruction manual.
•
Observing all local safety regulations.
•
Observing all warnings and cautions in the documentation regarding all products used in this
measurement system, including the Conductivity sensor, mounting hardware, analyzer
electronics and cabling.
•
Observing the prescribed environmental and operational conditions.
•
Observing chemical compatibility with all wetted materials.
1.3. Safety Instructions
The AnalogPlus 1.0 inch Contacting Conductivity sensor should be installed and
operated only by personnel familiar with the sensor and qualified for such work.
A defective sensor should be returned to Thermo Fisher Scientific for repair or
replacement. Contact Thermo Fisher Scientific to obtain a Return Material
Authorization (RMA) number.
No modifications to the AnalogPlus 1.0 inch Contacting Conductivity sensor are
allowed. The manufacturer/supplier accepts no responsibility for damage caused by
unauthorized modifications. The risk is borne entirely by the user.
1.4. Removal from Service / Correct Disposal of the Sensor
Removal from Service
•
Disconnect the cable wiring from the controller terminal block.
•
Remove the sensor from the mounting hardware.
Correct Disposal of Unit
•
When the sensor is taken out of service, observe the local environmental regulations for correct
disposal.
