Thermo Scientific Agilent 1100 Series, Руководство по подключению

Страница: 16 / 32

2
Connecting the Hardware
Installing a Network Card in an Agilent Module
6 Agilent 1100 Series Getting Connected Guide for LC Devices Thermo Scientific
2. To prevent damage to the interface board, ensure that you are using protection from
electrostatic discharge (ESD). For more information on preventing damage caused by an
electric discharge, refer to the reference manual for the Agilent module.
3. To remove the cover plate from the slot where you plan to install the network interface
card, loosen the two screws that fasten the plate to the chassis of the module.
Figure 4 shows the location of the cover plate on the back panel of an Agilent 1100 Series
detector.
Figure 4. Back panel of an Agilent 1100 Series detector
4. Record the MAC address (12-digit hexadecimal number) located on the back of the
HP JetDirect 400N network card. You use this number to complete the configuration of
the Agilent stack (see
Figure 9 on page 12 ).
5. Insert the HP JetDirect 400N network card into the slot, and then tighten the two screws
that fasten the PCB to the chassis of the module.
CAUTION To prevent damage to an instrument, always use ESD protection when
handling electronic boards and components.
ANALOG ANALOG RS232 RS232 CAN CAN
Cover plate