Thermo Scientific 75003623, Инструкция по эксплуатации

Страница: 19 / 41

3
AutoLock
™
Removing the Rotor
Thermo Scientific 75003623 CLINIConic 30 x 15 3-3
4. Close the centrifuge lid.
Removing the Rotor
To remove the rotor, proceed as follows:
1.
Open the centrifuge lid.
2.
Grab the rotor handle with both hands and press against the green AutoLock
™
key. At the same
time, pull the rotor directly upwards with both hands and remove it from the motor shaft. Make
sure not to jam the rotor while doing this.
CAUTION
Check that the rotor is properly locked on the shaft before each use by pulling its
handle.
Be sure to check all seals before starting any aer
o
sol-tight applications.
See the information in the rotor instruction manual.
Figure
3- 2
.
Handling the AutoLock
™