WARNING: Before installing tubing into the Pump Head
remove power or shut off the drive. Fingers or loose clothing
could be caught in the rollers.
1. Place the Power On/Direction Switch, Figure 1-2, in the center (Off )
position.
2. Open the Door, Figure 1-2, by grasping the finger recesses on either
side and pulling away from the pump.
3. Release the Occlusion Bed, Figure 2-1, by squeezing the Locking Tabs,
Figure 2-1, together and sliding the bed down towards the door hinge.
Figure 2-1.
Occlusion Bed in Unlatched Tube Loading Position
4. Holding both ends of the tubing in one hand, form a loop and wrap
the tubing around the Rollers, Figure 2-1, making sure that the tubing
is centered on the Rollers and keeping the free ends of the tubing
outside of the Tubing Retainers, Figure 2-1.
2-2
FH10 MICROFLEX
®
Pump System Operating Manual
Thermo Scientific
Section 2
Installation and Setup
Installing Tubing
in Pump Head
Tubing
Retainers
Locking Tab
Rollers
Locking
Tab
Recess –
Push Here
to Close
Bed
Occlusion
Bed
