8
Model 60
i
Quick Start Guide
Thermo Fisher Scientific
Rear Panel
Connector Pin
Terminal Block
Screw Number
Signal Description
5 17 Analog_In4
6 18 Analog_In5
7 19 Analog_In6
8 20 Ground
9 21 Analog_In7
10 22 Analog_In8
11 23 Ground
14 24 Ground
Before the power cord is connected, be sure that the front panel power
switch is OFF and be sure to verify that the local power matches the label
on the back of the analyzer.
WARNING
The Model 60
i
is supplied with a three-wire grounded power
cord. Under no circumstances should this grounding system be defeated.
▲
Use the following procedure when starting the instrument.
1.
Turn the power ON and allow two hours for the instrument to
stabilize.
2.
Set instrument parameters such as operating ranges and averaging times
to appropriate settings. For more information about instrument
parameters, see the “Operation” chapter in the “Model 60
i
Instruction
Manual.”
3.
Before beginning the actual monitoring, perform a calibration as
described in the “Calibration” chapter in the “Model 60
i
Instruction
Manual.”
Power Connections
Startup
