8
ENGLISH
END USER
END USER
RECYCLING AND DISPOSAL
The device is primarily composed of:
Material
Component
steel
structural work
PU (polyurethane)
insulation
ABS (acrylonitrile-butadiene-styrene)
lining and covers
At the end of the device's useful life, these components must be separated and disposed of according to current regulations in
the country of installation.
END USER INSTRUCTIONS
Refer to the GENERAL SAFETY INFORMATION and PRECAUTIONS section for safety-related information.
START-UP
The heater commissioning must be performed by Technical
Assistance Centre personnel.
Under certain circumstances, such as after long periods of
disuse, the user may need to re-start it without involving the
Technical Assistance Centre. Before doing so, perform the fol-
lowing checks and operations.
- Check that the supply cocks in the domestic water cir-
cuit are all open
- Switch the electricity supply ON at the mains power
switch and at control panel switch (if fitted).
TEMPORARY SHUTDOWN
To reduce to the environmental impact and save energy, in
case of brief absences, week-ends, short trips, etc., and with
external temperatures above 0°C, set the heater temperature
control, where available, to the minimum value.
b
If the temperature to which the heater is exposed can
fall below 0°C (frost hazard), perform the operations de-
scribed in paragraph "Preparing for extended periods of
disuse".
PREPARING FOR EXTENDED PERIODS
OF DISUSE
If the storage cylinder is not going to be used for an extended
period of time, ask the manufacturer’s Technical Assistance
Centre to make the system safe.
EXTERNAL MAINTENANCE
Clean the outside of the storage cylinder with a soft cloth
damped in soapy water.
a
Do not use abrasive products, petrol or triethylene.
End user
RIELLO S.p.A.
Via Ing. Pilade Riello, 7
37045 - Legnago (VR)
www.thermital.it
The manufacturer strives to continuously improve all products. Appearance,
dimensions, technical specifications, standard equipment and accessories are
therefore liable to modification without notice.
