1
Common settings
1.1
Quick guide
Use the buttons to manoeuvre the menu.
HOT WATER
HEATING
AUX.HEATER
MANUEL TEST
INSTALLATION
SERVICE
Enter/set
Back/exit
Up/increase temperature (+)
Down/decrease temperature
(-)
Below is a summary of the most common settings you may need to make as owner of this heat pump.
▪
Adjusting the indoor temperature is easy by adjusting the ROOM value:
▪
Press
or
buttons once to open and change the ROOM value.
▪
Adjust by pressing the
or
buttons, one step will alter the indoor temperature approxi-
mately 1°
▪
Wait 10 seconds or press the left button
to exit the menu
Note! If it is to warm (or cold) in the house, it is important to regulate the indoor temperature by adjusting the
settings in the heat pump display. Avoid turning down radiator thermostats or floor heating thermostats to
reduce room temperature. With open thermostats you will extend the lifespan of the heat pump and you often
also save more money as the heat pump will run more efficient.
Observe that the effect of the adjustment takes up to approximately 24 hours to be noticeable, depending on
the heating system and insulation of the building etc.
▪
Display notifications (Alarms) or no hot water
If an event occurs that triggers the alarm, this is indicated in the display with the text "ALARM" and relevant
alarm message. Make a note of the alarm message, the alarm can often be reset once by setting the heat pump
to operating mode
OFF and then back to desired operating mode. For more information about alarms go
to the Alarm chapter.
User Guide
Thermia Legend
BWLE01UG0102
Thermia AB
4
