M 520232061204092018
THERMEX
MANcHESTER SMART
39
EN
gl
ISH
»
E
LE
cTRI
cAL
INS
TALL
ATION
INSTALLING UNDER A cUPBOARD
Installing the hood at the bottom of a cupboard is carried out as follows:
ELECTRICAL INSTALLATION
connect the hood to the electrical mains socket using the installed plug. The wire on the hood is 1.4 metres long.
NOTE: The hood is double-insulated and does therefore not need to be earthed.
Tighten the screws in order to secure the
hood to the wall.
Replace the filters back in the hood.
8
7
Install the exhaust outlet on the hood.
NOTE: This only applies when venting into
open air.
9
Measure out and mark the position of the
four mounting holes on the bottom of the
cupboard.
Pre-drill the holes in the bottom of the cup-
board.
Measure out and mark the position of the
hood’s exhaust on the bottom of the cup-
board.
NOTE: This only applies when venting into
open air.
cut a hole in the bottom of the cupboard for
the exhaust.
NOTE: This only applies when venting into
open air.
Mount the hood using four screws that
match the material into which they are being
screwed.
Install the exhaust outlet on the hood.
NOTE: This only applies when venting into
open air.
6
1
2
3
4
x4
5
