16
OwNER’s mANuAl
CHAuFFE-PIsCINE
COMMERCIAL
POOl HEAT PumP
For 2 wire remotes
1. Bring up « POl » setting and arrow temperature down until pool setting
reads « off ».
2. Bring up « sPA » setting and arrow temperature up until spa setting reads 104.
3. set unit to the « POl » mode.
4. Connect remote system with 2 wires to the P/s terminal on control board.
Figure 6 shows you where to connect the 2 wire remote systems to the
temperature controller.
For 3 wire remotes
1. Bring up « POl » setting and use arrows to select desired pool temperature.
2. Bring up « sPA » setting and use the arrows to select the desired spa tem-
perature.
3. set unit to « POl » mode.
4. Connect the commun and high (or spa) wires to the « P/s » terminals on
control board (see specific model diagram). low or pool wire does not get
connected.
Fig. 6
