Installation Guideline
the installation must be in compliance with the national electrical
regulations and your local electrical and plumbing codes.
1. Make sure the appliance is intact, and the fittings are complete.
2. Please make sure the main power supply, water pressure, grounding condition,
ammeter and wire reach the standard of installation requirement.
3. The appliance must be connected to properly grounded dedicated branch
circuits of proper voltage rating.
4. If you will not use the tap for long time, please switch off the leakage protection
plug.
5. Position the unit upright with all plumbing connections at the bottom of the unit.
6. During the installation, water supply must be tested for adequate flow before
turning on the power supply..
Installation Method
INstallINg the uNIt
1.
The appliance can fit 2 different mode of power connection, 1) power connection is
above the table-board; 2) power connection is below the table-board; Please confirm
the power connection mode first. Below are the installed assembly drawings.
2.
Make the water inlet connection pass through the pedestal, place the power cord into
the cavity of pedestal. Please refer below
fig 2-a
and
fig 2-B
.
Fig 1.
a.
Power cord connect
above the table-board.
Fig 2.
a.
Power cord connect above the table-board.
Fig 2.
B.
Power cord connect under the table-board.
Fig 1.
B.
Power cord connect
under the table-board.
Excellence in Hot Water Technology.
6
7
ThermaQ Specification Hotline 01924 270847
Power
Cord
Hand
Shank
Power
Cord
Hand
Shank
Power
Cord
Pedestal
Hand
Shank
Power
Cord
Pedestal
Hand
Shank
Hold-Down Nut
Table
Board
Power
Cord
Rubber Mat
Pedestal
Hand
Shank
Hold-Down Nut
Table
Board
Power
Cord
Rubber Mat
Pedestal
Hand
Shank
