Thermann TIHP 300, Инструкция по эксплуатации и монтажу

Страница: 13 / 28

INSTALLATION INSTRUCTIONS 13
26
_0
3_0
1_
13
88
f f
Tilt the water heater that has been set down on the polystyrene® installation aids.
f f Remove the remaining floor semi-shell.
f f
In the tilted state of the water heater, wind out the second and third leveling foot, but not by
more than 30 mm (1.1”).
f f
In both cases, tighten the locking nut against the bottom cover.
f f Position the water heater on the three leveling feet.
f f
Level the water heater vertically by adjusting the three leveling feet.
f f Remove any packaging that remains on the water heater.
removInG the tranSport locK
There is a two-part transport lock attached to the heat pump unit of the appliance. The transport lock must be re-
moved before the appliance is installed.
note
In its delivered condition, the appliance cover is held in place with only 4 screws.
The remaining screws for the appliance cover can be found in a plastic bag supplied with the appliance, in
the lower section of the appliance packaging.
f f Undo the 4 screws in the appliance cover and remove the cover to open the appliance.
f f
Remove the notice about secure transport which is fixed between the appliance casing and cover.