Thermann 125THM118, Руководство пользователя

Страница: 4 / 16

2
Thermann Owner’s Guide
Electric and Gas Storage Water Heaters
INSTALLATION REQUIREMENTS
General:
Your water heater must be installed
by a licensed tradesperson, and in
accordance with:
• AS/NZS 3500.4 Plumbing and
Drainage – Heated Water Services.
• Clause G12 of the NZ Building Code
(in New Zealand).
• AS/NZS 3000 Electrical
Installations (known as the
Australian / New Zealand Wiring
Rules).
• AS/NZS 5601.1 Gas Installations
– General Installations (for gas
storage water heaters).
• Local authority regulations.
• Outside Australia and New Zealand,
please refer to local plumbing and
building codes and regulations.
Failure to comply with these
requirements may affect the warranty.
Note for Victorian Customers:
Your water heater must be installed by
a licensed person as required by the
Victorian Building Act (1993).
Only a licensed person will provide a
compliance certificate, showing that
the work complies with all the relevant
Standards. Only a licensed person
will have insurance protecting their
workmanship.
Make sure you use a licensed person
to install your water heater and ask for
your Compliance Certificate.
Location:
Your water heater should be located
as close as possible to the most
frequently used hot water outlet.
Ensure the compliance plate and
associated warnings are clearly visible.
Your water heater must be accessible
without the use of a ladder or scaffold.
Adequate clearance must be available
for service to your water heater. All
models are equipped with a sacrificial
anode, accessed through the top
cover.
Gas storage water heaters must be
installed outdoors. The gas installation
standard specifies minimum clearances
to features such as windows and
doors.
Electric storage water heaters may be
installed indoors. The heated water
services standard requires that a
properly drained safe tray must be
installed where property damage
could occur from water spillage
Note - the warranty will not cover
damage due to leakage of the water
heater if a properly drained safe tray
has not been installed.
Water Heater Support:
Your water heater must be installed
on a flat, solid supporting surface. The
pipework must not be used to support
the water heater.
Pool Heating:
Your water heater must
not
be used
for pool heating.