Page 6 of 14
INSTALLATION INSTRUCTIONS
UNPACKING Prepare Air Conditioner for Installation
1. Location provided bags of screws.
2. Place the top channel on top of the air conditioner, lining up the
holes in top channel with the holes on top of air conditioner.
3. Using 2-#8 x 3/8” pan-head screws, attach top channel to air
conditioner.
NOTE
:
Your model may differ from the one shown.
Remove packaging materials
•
Remove and dispose or recycle all packaging materials.
Remove tape and glue residue from surfaces before
turning on the air conditioner. Rub a small amount of liquid
dish soap over the adhesive with your fingers. Wipe with
warm water and dry.
•
Do not use sharp instruments, rubbing alcohol, flammable
fluids or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
•
Handle air conditioner gently.
Window Installation (on some models)
NOTES:
•
Handle air conditioner gently.
•
Be sure your air conditioner cabinet does not fall out of the
opening during installation or removal.
•
The location where the power cord exits the air conditioner
Should be no more than 4 ft (122cm) from a grounded
3 prong outlet.
•
Do not block the louvers on the front panel.
•
Do not block the louvers on the outside of the air conditioner.
________________________________________________________
Install side curtains
________________________________________________________
NOTE
: Attach curtains to unit before placing unit in window.
1.
Remove unit from packaging.
2.
Locate provided bag of screws.
3.
Insert top and then bottom of right-hand curtain housing in top and
bottom curtain channels on air conditioner.
4. Extend right-hand curtain outward so you may insert a #8 x 3/4”
Round-head screw through the top hole of the curtain.
Using #8 x 3/8” screw, screw curtain to top hole in air conditioner cabinet.
NOTE
: This screw is required
to correctly attach curtain
(top to bottom) to the
air conditioner cabinet.
5. While the right-hand curtain is still extended,
insert screw in the
bottom slot of the curtain. Using #8 x 3/8” pan-
head screw, screw
The curtain to the bottom hole in the air
conditioner cabinet.
6. Slide the curtain housing into the channels as
far as it will go.
7. Repeat above steps for the left-hand curtain.
