background image

TROUBLESHOOTING 

 

If your heater shuts off unexpectedly: 

1.  Be sure the power cord is plugged into a working outlet. 
2.  Check for any obstructions.  If you find one, turn the heating unit OFF and 

unplug it.  Wait at least 10 minutes to allow the heating unit to cool com-
pletely before removing any obstruction.  When done, plug in the unit and 
follow the Operation Instructions.  

 

If your fireplace tips over:

 

1.  Set the unit back in its upright position and check for any damage.  If 

damage is detected, unplug unit and contact customer service for further 
assistance.   

2.  If no damage is detected, push the power button to turn the unit back on.     

 

If your fireplace does not illuminate properly: 

1.  The light bulbs may have vibrated loose and need to be tightened.   
2.  The light bulbs may be damaged and need to be replaced. 

 

FIREPLACE MAINTENANCE 

 

WARNING:  Disconnect power before attempting any maintenance or 
cleaning to reduce risk of fire, electric shock to persons or damage.  
Be sure unit has cooled completely, or severe burns could result. 

 

LIGHT BULB REPLACEMENT 

Light bulbs need to be replaced when you notice a dark section of the flame 
or when the clarity and detail of the log exterior disappears.  There are two 
bulbs under the log set. 

 

WARNING:  Allow at least 5 minutes for the light bulbs to cool off 
before touching bulbs to avoid burning skin. 

 

BULB REQUIREMENTS 

The fireplace uses 2 clear 40 watt chandelier or candelabra bulbs with an E-
12 (small) socket base, rating voltage 120 volts.  

 

CAUTION:  Do not exceed 40 watts per bulb. 

 

CHANGING LIGHT BULBS 
Unplug the unit first.  

1.  Using a Phillips screw driver, remove 6 screws to open the light bulb 

area:  Hold left and right side of the cover at the bottom of your firebox 
and pull straight out.  You can see two bulbs in the firebox. 

2.  Examine the bulbs to determine which bulbs require replacement. 
3.  Remove old bulb and replace with a new one.  Hold the socket while un-

screwing or screwing bulbs. 

4.  Replace cover.   

Содержание INFRARED FIREPLACE









Отзывы: